AQCT-2 LED Controller

Set up Instructions

1.) SKYLIGHT AQCT-2 – introduction

The AQCT-2 controller has been designed for adjusting color and brightness of Skylight lights: HYPERSPOT, PRI & PR series. It is additionally compatible with Skylight lights: TINY, PRO and MID series in which It can be used for adjusting brightness only.

Daytime cycle including sunrise and sunset simulation can be programmed individually for each of he 2 channels. To allow for easier configuration with dual channel lights have been named as W-warm and C-cold which fits their actual function.

2.) The controller main screen functionality.

3.) Menu – navigation

4.) Setting current time

5.) Information about the controller charging.

AQCT-2 has been equipped with a so called supercup, which – fully loaded will sustain the clock function for roughly 10 hours without the power supply. If the blackout lasts for a longer period of time – clock will need to be set once again.

6.) Modes:

a) OFF

Output is off

b) MANUAL mode

Cold (C) and warm (W) channel brightness can be adjusted individually.

c) DEMO mode

DEMO mode has been prepared to quickly present the range of color change for certain skylight lamp model. Sunrise and sunset sequency is performer in a loop.

d) AUTO mode

AUTO mode is the basic operation mode of the controller. It allows for sunrise and sunset simulation and setting a certain daytime and moonlight level.

7.) Quick start with the use of factory default settings.

Depending on the lamp used a preset day cycle for auto mode can be set. WARNING: only use this function for quick start as it will delete all user settings replacing them with factory setup.

8.) Day and night cycle in the AUTO mode.

The AQCT-2 timer allows for setting a day cycle with 4 elements – night, sunrise, day, sunset. This can be set separately for each of the 2 channels (W-warm and C-cold). In the menu those 4 periods are labeled with following icons:

9.) Setting the sunrise sequence and the daytime brightness in the AUTO mode.

Sunrise sequence is set separately for each of the 2 channels. Below some example settings for the W-warm channel are presented with explanation:

10.) Setting the sunset sequence and the daytime brightness in the AUTO mode.

Sunset sequence is set separately for each of the 2 channels. Below some example settings for the W-warm channel are presented with explanation:

11.) Display sleep mode.

Due to display lifetime preservation the display will go into sleep mode after certain idle time. This time [S] can be adjusted:

SETTINGS->OLED, PWM